GlowShift Universal Black Triple Pillar Gauge Pod - Fits Any Make/Model - ABS Plastic - Mounts (3) 2-1/16" (52mm) Gauges to Vehicle's A-Pillar

Fit just fine on my 1992 firebird. Only thing I would improve on with this product is to have Pre-drilled holes to put the screws through.

I ordered this product during a custom gauge installation that I was doing on my 1993 Honda Del Sol, and was quite skeptical of how it would fit on my door post since it is a "universal fit" after all, and you know how that can be. But when it came and I test fitted it, I was amazed at how closely it matched the contour of my Sol's door post. The angle at which the gauges look at you is perfect and it fits almost perfectly on the length of the post. The arch is slightly more than the Del Sol's post, but I filled the gap with some of the insulating foam that came with the product and it is a perfect fit for my car. I liked this product so much that I just ordered another one to go on the passenger side door panel. I can't say that it would fit this good on every car, but on mine it sure did. I hope this helps those with a similar situation to mine!

Easy to install

Diffinately a bit on the big side for my 1994 3000gt. But with some heat and some gloves,you can make it work. Worst part for me was getting it to fit, but after 20 min of messing with it, its molded to my inner panel and the gauges still fit nice and tight. I think worth it for the money if you dont mind doing a little molding. I had some pretty good heat going to it with a torch and it didnt catch on fire or anything, but dont be stupid either, use little amounts of heat along the edge and around the bends on the back side, and use some thermal gloves to help grab it and let it take shape.

Isnt shaped right to hug pillar, no hardware for mounting. Not sure what the extensive foam is for either.

Got this for my 2011 Nissan Juke. The cost is very reasonable and with some work I believe you could fit this to virtually any vehicle. If you are not confident of using a heat gun to mold a product I would still recommend this product, but advise you to not expect results greater than what you can provide. It does work well and the look is what I was expecting and it didn't cost me over $200.00. I now have three gauges (Oil Temperature, Oil Pressure and Turbo boost) to monitor my engines performance, where I had none before. Gauges do not come with the item.

Great value for the $$. Like others have said, I had to remove the windshield trim, and use a heat gun to mold it around the trim. I'm guessing that this would fit many vehicles, if the same process was used. I am happy with my purchase, and the pillar compliments my 99 Ranger 302 swap well. Thank you! 👍

Llego en buen estado y según características.! A tiempo.!